Acreage limitations — Us Code Code § 1006

Us Code Code § 1006 — Acreage limitations. Reproduced from the official United States Code, with a citation summary, verification link, and related provisions.

§ 1006. Acreage limitations

A geothermal lease shall embrace a reasonably compact area of not more than 5,120 acres, except where a departure therefrom is occasioned by an irregular subdivision or subdivisions. No person, association, or corporation, except as otherwise provided in this chapter, shall take, hold, own, or control at one time, whether acquired directly from the Secretary under this chapter or otherwise, any direct or indirect interest in Federal geothermal leases in any one State exceeding 51,200 acres, including leases acquired under the provisions of section 1003 of this title.

(Pub. L. 91–581, §7, Dec. 24, 1970, 84 Stat. 1569; Pub. L. 109–58, title II, §235, Aug. 8, 2005, 119 Stat. 671.)


Editorial Notes

Amendments

2005—Pub. L. 109–58 inserted section catchline, substituted "5,120 acres" for "two thousand five hundred and sixty acres" and "51,200 acres" for "twenty thousand four hundred and eighty acres" in text, and struck out second par. which read as follows: "At any time after fifteen years from December 24, 1970, the Secretary, after public hearings, may increase this maximum holding in any one State by regulation, not to exceed fifty-one thousand two hundred acres."

About This Section

30 U.S.C. § 1006 is part of Title 30 of the United States Code. The United States Code is the official codification of federal statutes maintained by the Office of the Law Revision Counsel of the U.S. House of Representatives. Congress amends the Code through new public laws, which are eventually incorporated into the relevant title.

This section may be cited in legal writing as 30 U.S.C. § 1006. For the most current official text, including any recent amendments, use the official source links below. Do not rely on this page as the sole authority for legal citation or litigation.

How to Read This Statute

Statutes are organized by title, chapter, section, and subsection. Pay attention to words like "shall," "may," "and," and "or," because they determine whether a requirement is mandatory or permissive and whether multiple conditions must all be met. Historical notes and amendments often appear at the end of a section.

Using This Page

This page is intended for research and educational use. Lawyers, students, journalists, and compliance professionals can use it as a starting point, but should always verify the current text through an official government source before relying on it for legal advice, filings, or compliance decisions.

Sources

Source: official Us Code text · Last verified 2026-08-27

At a glance

Verify the text

Statute text is transcribed from the official United States Code. Confirm it against the primary source before relying on it:

Not legal advice. Verify against the official source and consult a licensed Us Code attorney.

Common questions

What is the source of United States Code § 1006?

The text above is transcribed from the United States Code, the codified statutes of Us Code. The official publisher link appears under "Verify the text" on this page.

What subject does United States Code § 1006 address?

It addresses "Acreage limitations". Read the section together with the surrounding provisions listed under "Nearby provisions" for the full picture.

Is United States Code § 1006 still in force?

Statutes are amended, repealed, and renumbered every session. Confirm the current version at the official Us Code source before relying on this text.

Can this page be used as legal advice?

No. This is a reference transcription for research. Applying Us Code law to your facts requires a licensed Us Code attorney who can review the specifics.